DC-DC Dönüştürücülerin Modellenmesi ve Simülasyonu

Year 2021, Volume: 17 Issue: 1, 30 - 41, 30.06.2021

Evren İşen

Abstract

Keywords

yükseltici dönüştürücü, düşürücü dönüştürücü, düşürücü-yükseltici dönüştürücü, dönüştürücü modelleme

Modeling and Simulation of DC-DC Converters

Abstract

DC-DC converters are used in many types industrial applications. They are used to change the DC source voltage level to higher or lower level. In recent years, as the use of photovoltaic systems increases, DC-DC converters have got more important. In this study, the basic DC-DC converters, named boost, buck and buck-boost converters, are modeled and simulated in Matlab/Simulink. The detailed circuit equations and derived models from that equations for each switching modes are presented in the study. The obtained results from converter models are verified with electrical simulations that is utilized Simulink blocks. Closed-loop control is used in both methods. Both simulations are realized in the same conditions, such as controller parameters, circuit parameters and simulation options in Simulink. Transient-state with load change and steady-state response of both methods are compared in the study. The output voltages of each methods and difference waveforms are given in the results. They show that the presented models can be used for simulation of these converters.

Keywords

boost converter, buck converter, buck-boost converter, converter modeling

References

• E.K. Sato, M. Kinoshita and K. Sanada, “Double DC-DC converter for uninterruptible power supply applications”, The 2010 International Power Electronics Conference (ECCE-ASIA), pp. 635-642, June 2010.
• J.H. Ah and B.K. Lee, “High-Efficiency Adaptive-Current Charging Strategy for Electric Vehicles Considering Variation of Internal Resistance of Lithium-Ion Battery”, IEEE Transactions on Power Electronics, Vol. 34, No. 4, pp. 3041-3052, April 2019.
• I. Febriyandi, F.D. Wijaya and E. Firmansyah, “DC-DC converter as power supply of battery charger 100 V 300 W using 25 kHZ switching frequency”, International Conference on Electrical Engineering and Computer Science (ICEECS), pp. 302-307, Nov. 2014.
• C. Laksmanasamy and P. Rathinasamy, “Design and Simulation of Boost Converter with MPPT Techniques”, International Journal of Advances in Computer and Electronics Engineering, Vol. 2, No. 5, pp. 1-6, May 2017.
• V.K. Vishwhak and S. Ramalingam, “Design and Simulation of Superlift DC-DC Converter for Solar PV Applications”, International Journal of Advances in Computer and Electronics Engineering, Vol. 2, No. 9, pp. 22-28, September 2017.
• T.H. Nguyen and D.C. Lee, “A novel current control scheme of grid converters for small PMSG wind turbines under grid voltage distortion”, IEEE Power Electronics and Machines in Wind Applications (PEMWA), pp. 1-6, July 2012.
• S.M. Alagab, S.B. Tennakoon and C.A. Gould, “A Compact DC-DC Converter for Offshore Wind Farm Application”, International Conference on Renewable Energies and Power Quality (ICREPQ’17), pp. 529-533, April 2017.
• S. Farhani, E.M. Barhoumi and F. Bacha, “Design and hardware investigation of a new configuration of an isolated DC-DC converterfor fuel cell vehicle”, Ain Shams Engineering Journal, https://doi.org/10.1016/j.asej.2020.07. 014. S. Bairabathina and S. Balamurugan, “Review on non-isolated multi-input step-up converters for grid-independent hybrid electric vehicles”, International Journal of Hydrogen Energy, Vol. 45, No. 41, pp. 21687-21713, August 2020.
• Y. Song and B. Wang, “A photovoltaic power conversion system with flat efficiency curve over a wide load range”, 37th Annual Conference of the IEEE Industrial Electronics Society, pp. 1144-1149, Nov. 2011.
• E. Isen and A. Sengul, “Comparison of Maximum Power Point Tracking Techniques on Photovoltaic Panels”, Çanakkale Onsekiz Mart Üniversitesi Fen Bilimleri Enstitüsü Dergisi, Vol. 6, No. 1, pp. 14-29, 2020.
• M. Alagu, P. Ponnusamy and S. Pandarinathan, “Performance improvement of solar PV power conversion system through low duty cycle DC-DC converter”, International Journal of Circuit Theory and Applications, Vol. 49, No. 2, pp. 267-282, 2020.
• S.S. Somalinga and K. Santha, “Modified high-efficiency bidirectional DC-DC converter topology”, Journal of Power Electronics, Vol. 21, pp. 257-268, 2021.
• Q. Qi, D. Ghaderi and J. Guerrero, “Sliding mode controller-based switched-capacitor-based high DC gain and low voltage stress DC-DC boost converter for photovoltaic applications”, International Journal of Electrical Power & Energy Systems, Vol. 125, pp. 1-19.
• M. Alkrunz and I. Yazici, “Design of discrete time controller for the DC-DC boost converter”, Sakarya Üniversitesi Fen Bilimleri Dergisi, Vol. 1, pp. 75-82, 2016.
• L. Mohammadian, E. Babaei, M.B.B. Sharifian, “Buck-Boost DC-DC Converter Control by Using the Extracted Model from Signal Flow Graph Method”, International Journal of Applied Mathematics, Electronics and Computers, Vol. 3, No. 3, pp. 155-160, 2015.
• O. Gungor and H.I. Yuksek, “Modeling of Boost and Cuk Converters and Comparison of Their Performance in MPPT”, Sigma Journal of Engineering and Natural Sciences, Vol. 11, No. 1, pp. 83-101, 2020.
• H. Ozbay, “Comparison of Sliding Mode and Fuzzy Logic MPPT Techniques for PV Systems”, Electronic Letters on Science & Engineering, Vol. 16, No. 1, pp. 26-35, 2020.
• J.R. Hernanz, J.M.L. Guede, O. Barambones, E. Zulueta and U. F. Gamiz, “Novel control algorithm for MPPT with Boost converters in photovoltaic systems”, International Journal of Hydrogen Energy, Vol. 42, pp. 17831-17855, 2017.
• N.H. Baharudin, T.M.N.T. Mansur, F.A. Hamid, R. Ali and M.I. Misrun, “Performance Analysis of DC-DC Buck Converter for Renewable Energy Applications”, Journal of Physics: Conference Series, Vol. 1019, 2018.
• K. Sundareswaran, V. Devi, S.K. Nadeem, V.T. Sreedevi and S. Palani, “Buck-Boost converter feedback controller design via evolutionary search”, International Journal of Electronics, Vol. 97, No. 11, pp. 1317-1327, 2010.