EFFECTS OF DENTAL AND ZYGOMATIC IMPLANTS ON STRESS DISTRIBUTION IN ZYGOMATIC BONE

Year 2014, Volume: 2 Issue: 3, 253 - 259, 30.12.2014

Canan Akay , Suat Yaluğ Mehmet Dalkız

Abstract

Prosthetic rehabilitation of the upper jaw in patients with expansive bone and soft tissue defects is still a significant problem lack of retantion and stability. Zygomatic implant is an alternative method for these patients. The purpose of this research was to evaluate the stress distribution in the zygomatic bone for three different implant-retained obturator prostheses configuration in a premaxillary with unilateral maxillary defect using a three dimensional finite element stress analysis. 3- dimensional finite element models were constructed based on computed tomograph data. Model 1; one zygomatic implant on defected side, two dental implant on nondefected side, model 2; two dental implant on nondefected side, model 3; one zygomatic implant on each side of the maxilla additionally one dental implant on non defected side. Bar attachments were used as superstructure. Vertical load 150 N was applied in three different ways and the stress distribution were observed and compared. In all loading conditions model 3 when compared another models, shows highest maximum principle stress value on zygomatic bone. Use of zygomatic implant with dental implant in the same part of the maxilla increased the stress values of the zygomatic bone

Keywords

Zygomatic implant, Obturator, Three- dimensional finite, element analysis, Stress distribution

DENTAL VE ZİGOMATİK İMPLANTLARIN ZİGOMATİK KEMİKTEKİ STRES DAĞILIMINA ETKİSİ

Abstract

Üst çenede geniş kemik ve doku defektlerine sahip olan hastalarda retansiyon ve stabilite eksikliği protetik rehabilitasyon için ciddi bir problemdir. Bu hastalarda zigomatik implantlar alternatif bir tedavi metodudur. Bu çalışmanın amacı premaksilla ile tek taraflı maksiller defektlerde, 3 farklı şekilde dizayn edilmiş implant destekli obturator protezin zigomatik kemikte yarattığı stresi üç boyutlu sonlu elemanlar stress analiz yöntemiyle değerlendirmektir. Üç boyutlu sonlu eleman modelleri bilgisayarlı tomgrafi verilerine dayandırılarak hazırlandı. 1. model de bir adet zigomatik implant defekt tarafına, iki adet dental implant defekt olmayan tarafa, 2. model de iki adet dental implant defekt olmayan tarafa, 3. model de; defekt olan ve olmayan tarafa birer adet zigomatik implant ilave olarak defekt olmayan tarafa bir adet dental implant yerleştirilmiştir. Üst yapı olarak bar ataçmanlar kullanılmıştır. Dikey yönde 150 N kadar dikey kuvvet üç farklı yolla uygularak gözlenmiş ve karşılaştırma yapılmıştır. Bütün yükleme koşullarında 3.model diğer modeller ile karşılaştırıldığında zigomatik kemikte en yüksek maximum principle stress değerini göstermiştir. Zigomatik implantın dental implant ile maksillanın aynı bölgesinde kullanılması zigomatik kemikte maksimum principle stres değerlerini artırmıştır.

Keywords

Zigomatik implant, Obturator, 3 boyutlu sonlu elemanlar, analizi, Stress dağılımı

References

• Ahila, S.C., Anitha, K.V., Thulasingam, C., 2011. Comparison of obturator design for acquired maxillary defect in completely edentulous patients. Indian Journal of Dental Research, 22, 1, 161-163
• Ahmed, B., Hussain, M., Yazdania, N., 2007. A blessing for maxillectomy patients - A case report. Pakistan Oral Dental Journal, 27, 127-8.
• Al-Nawas B., Wegener J., Bender C., Wagner W., 2004. Critical soft tissue parameters of the zygomatic implant. Journal of Clinical Periodontol, 31, 497-500
• Aparacio, C., Branemark, P-I., Keller, E.E., Olive, J., 1993. Reconstruction of the premaxilla with autogenous iliac bone in combination with osseointegrated. International Journal of Oral Maxillofacial Implants, 8, 61-7
• Aparicio, C., Fortes, V., Barluenga, N., 2010. Immediate/ Early Loading of Zygomatic Implants: Clinical Experiences after 2 to 5 years of follow up, Clinical Implant Dentistry and Related Research, 12, 1, 77-82
• Aparicio, C., Hatano, N., 2008. The use of zygomatic implants for prosthetic rehabilitation of severely resorbed maxilla. Periodontol 2000, 47, 162-171
• Aparicio, C., Quazzani, W., Garcia, R., Arevalo, X., Muela, R., Fortes, W., 2006. A prospective clinical study on titanium implants in the zygomatic arch for prosthetic rehabilitation of the atrophic edentulous maxilla with a follow-up of 6 months to 5 years, Clinical Implant Dentistry Related Research, 8, 114-122
• Chun, H.J., Park, D.N., Han, C.H., Heo, S.J., Heo, M.S., Koak, J.Y.,2005. Stress distributions in maxillary bone surroundings overdenture implants with different overdenture
• Rehabilitation, 32, 193–205. Journal of
• Oral Hu, Y.J., Hardianto, A., Li, S.Y., Zhang, Z.Y., Zhnag, C.P., 2007. Reconstruction of a palatomaxillary defect with vascularized iliac bone combined with a superficial inferior epigastric artery flap and zygomatic implants as anchorage International Journal of Oral and Maxillofacial Surgery, 36, 9,854–857
• Kato, Y., Kizu, Y., Tonogi, M., Ide, Y., Yamane., 2005.