Azo Dye Removal from Aqueous Solution by Powder Graphite: Investigation of Parameter Effects and Optimization by Box-Behnken Design

Yıl 2023, , 56 - 64, 06.03.2023

Sertel Görücü , Çisil Gülümser , Mesut Sezer , Sevil Veli

https://doi.org/10.28979/jarnas.1110677

Cited By: 1

Öz

Industrial wastewaters containing dyes comprise organics that are difficult to biodegrade and when they are discharged to receiving bodies, they cause serious impacts on environment. Therefore, this wastewater requires advanced treatment besides conventional ones. Adsorption is accepted one of the favorable processes, which can be applied integrative to conventional systems during the treatment of this wastewater. In addition to the effectiveness of the materials to be utilized in the adsorption process, their cost and availability are also very important factors. In this study, the efficiency of environmentally friendly, cost-effective powdered graphite was investigated in the removal of diazo type dye (Direct Red 243) from aqueous solution by adsorption. For this purpose, Response Surface Method was applied via Box-Behnken Design and the most effective parameters were investigated in dye adsorption with graphite. Also, the morphology of the graphite before and after adsorption was scanned by Scanning Electron Microscopy. Adsorption study was carried out in batch mode and pH (2-10), adsorbent amount (0.1-1.5 g) and time (15-65 min) were designated as experimental parameters. It has been observed that the most effective parameter in color removal of dye was pH and at low values of this parameters the higher efficiencies were obtained. Additionally, it was observed that the increase in the amount of adsorbent increased the efficiency, and time had no significant effect besides two parameters. Almost complete decolorization (98%) was acquired at pH 2 with 1.5 g adsorbent for 40 min of study. As a result of the study, even it is not improved with further applications, graphite can be effective for anionic dye color removal under acidic conditions by its pristine form.

Anahtar Kelimeler

Anionic dye, Box-Behnken Design, decolorization, experimental design, graphite adsorption

Kaynakça

• Adeyemo, A. A., Adeoye, I. O., & Bello, O. S. (2017). Adsorption of dyes using different types of clay: a review. Applied Water Science, 7(2), 543–568. https://doi.org/10.1007/s13201-015-0322-y
• Barišić, A., Lützenkirchen, J., Bebić, N., Li, Q., Hanna, K., Shchukarev, A., & Begović, T. (2021). Experimental data contributing to the elusive surface charge of inert materials in contact with aqueous media. Colloids and Interfaces, 5(1). https://doi.org/10.3390/colloids5010006
• Berradi, M., Hsissou, R., Khudhair, M., Assouag, M., Cherkaoui, O., El Bachiri, A., & El Harfi, A. (2019). Textile finishing dyes and their impact on aquatic environs. Heliyon, 5(11). https://doi.org/10.1016/j.heliyon.2019.e02711
• Bhaumik, M., McCrindle, R., & Maity, A. (2013). Efficient removal of Congo red from aqueous solutions by adsorption onto interconnected polypyrrole-polyaniline nanofibres. Chemical Engineering Journal, 228, 506–515. https://doi.org/10.1016/j.cej.2013.05.026
• Dahri, M. K., Kooh, M. R. R., & Lim, L. B. L. (2014). Water remediation using low cost adsorbent walnut shell for removal of malachite green: Equilibrium, kinetics, thermodynamic and regeneration studies. Journal of Environmental Chemical Engineering, 2(3), 1434–1444. https://doi.org/10.1016/j.jece.2014.07.008
• Esmaeli, A., Jokar, M., Kousha, M., Daneshvar, E., Zilouei, H., & Karimi, K. (2013). Acidic dye wastewater treatment onto a marine macroalga, Nizamuddina zanardini (Phylum: Ochrophyta). Chemical Engineering Journal, 217, 329–336. https://doi.org/10.1016/j.cej.2012.11.038
• Gengec, E., Ozdemir, U., Ozbay, B., Ozbay, I., & Veli, S. (2013). Optimizing dye adsorption onto a waste-derived (modified charcoal ash) adsorbent using box-behnken and central composite design procedures. Water, Air, and Soil Pollution, 224(10). https://doi.org/10.1007/s11270-013-1751-6
• Ghaedi, A. M., Ghaedi, M., Vafaei, A., Iravani, N., Keshavarz, M., Rad, M., … Gupta, V. K. (2015). Adsorption of copper (II) using modified activated carbon prepared from Pomegranate wood: Optimization by bee algorithm and response surface methodology. Journal of Molecular Liquids, 206, 195–206. https://doi.org/10.1016/j.molliq.2015.02.029
• Kumar, A., Prasad, B., & Mishra, I. M. (2007). Process parametric study for ethene carboxylic acid removal onto powder activated carbon using Box-Behnken design. Chemical Engineering and Technology, 30(7), 932–937. https://doi.org/10.1002/ceat.200700084
• Malakootian, M., Mansoorian, H. J., Hosseini, A., & Khanjani, N. (2015). Evaluating the efficacy of alumina/carbon nanotube hybrid adsorbents in removing Azo Reactive Red 198 and Blue 19 dyes from aqueous solutions. Process Safety and Environmental Protection, 96, 125–137. https://doi.org/10.1016/j.psep.2015.05.002
• Yagub, M. T., Sen, T. K., Afroze, S., & Ang, H. M. (2014). Dye and its removal from aqueous solution by adsorption: A review. Advances in Colloid and Interface Science, 209, 172–184. https://doi.org/10.1016/j.cis.2014.04.002
• Yetilmezsoy, K., Özçimen, D., Koçer, A. T., Bahramian, M., Kıyan, E., Akbin, H. M., & Goncaloğlu, B. İ. (2020). Removal of Anthraquinone Dye via Struvite: Equilibria, Kinetics, Thermodynamics, Fuzzy Logic Modeling. International Journal of Environmental Research, 14(5), 541–566. https://doi.org/10.1007/s41742-020-00275-0