Comparison of Gamma Sources (Cobalt and Cesium) for Density Measurement of Metals and Alloys via Using Transmission Technique

Yıl 2021, Cilt: 6 Sayı: 1, 37 - 43, 30.04.2021

Muttalip Ergun Turgay

https://doi.org/10.30931/jetas.891679

Cited By: 1

Öz

One of the solutions for density measurement is to make use of gamma-ray transmission technique. We studied by this technique, using by Co-60 and Cs-137. Each source, without materials in geometry, was counted and noted intensities as (I0). All materials were counted and noted intensities as (I). [I/I0] rates were calculated. Now, density of materials could be determined via using Beer-Lambert Equation. Experimental application was performed on industrial metals or metal alloys like lead&copper and steel&brass. Given densities and obtained densities were compared. Differences or deviations for lead, stell copper and brass are -5.07; 0.26; 1.11; -5.73 (Co-60) and 1.07; 3.08; -0.22; 2.34 (Cs-137) consequently. It could be said that, these differences are still in acceptable limits.

Anahtar Kelimeler

Co-60/Cs-137, metal/alloy, Co-60/Cs-137, density measurement, metal/alloy, gamma-transmission technique, nuclear applications, nuclear technique

Kaynakça

• [1] Mix, P.E., “Introduction to non-destructive testing”, John Wiley, New York, (1987).
• [2] Turgay, M.E., “Density assessment of different metals and alloys by gamma-ray transmission technique via using Co-60 radioactive source”, Journal of Physical Science and Application 7(1) (2017) : 39–42.
• [3] Földiak, G., “Industrial application of radioisotopes”, Institute of Isotopes of the Hungarian Academy of Sciences, Budapest, (1986).
• [4] Buyuk, B., “Gamma attenuation behavior of some stainless and boron steels”, Acta Physica Polonica A 127(4) (2015) : 1342-1345.
• [5] Buyuk, B., Tugrul, A.B., “An investigation on gamma attenuation behaviour of titanium diboride reinforced boron carbide–silicon carbide composites”, Radiation Physics and Chemistry 97 (2014) : 354-359.
• [6] Moreira, A.C., Appoloni, C.R., Fernandes, C.P., “Gamma ray transmission technique applied to porous phase characterization of low-porosity ceramic samples”, Materials and structures 46(4) (2013) : 629-637.
• [7] Karagoz, B., et al. “Determination of Gamma Transmittance and Density Assessment for Al Doped ZnO Thin Films by Using Gamma Transmission Technique”, Defect and Diffusion Forum 312–315 (2011) : 830–835, https://doi.org/10.4028/www.scientific.net/ddf.312-315.830.
• [8] Bjoernstad, T., Stamatakis, E., “Scaling studies with gamma transmission technique”, Conference: Oil Field Chemistry, At: Geilo, Norway, (2006).
• [9] Course Notes, Radiation Detectors, Chapter 18, Oregon State University.
• [10] Gardner, R.P., Ely, R.L., “Radioisotopes Measurement Applications in Engineering”, Reinhold Publishing Co., New York, (1967).
• [11] Bilge, A.N., Tuğrul, A.B., “Bases of Industrial Radiography”, I.T.U. Publishing, Istanbul, (1990).
• [12] Turgay, M.E., “Density measurement for different metals by gamma-ray transmission technique used by radioactive isotopes”, M.Sc. Thesis, Istanbul Technical University, Istanbul, (2005).