Numerical comparison study on heat transfer enhancement of different cross-section wire coils insert with varying pitches in a duct

Yıl 2021, Cilt: 7 Sayı: 7, 1683 - 1693, 18.11.2021

Taha Tuna Göksu , Fuat Yılmaz

https://doi.org/10.18186/thermal.1025930

Cited By: 2

Öz

Heat transfer enhancement (HTE) efforts spent during the last half-century have become one of the most important working areas of researchers from both academia and industry. One of the most popular passive methods, with regard to the price-performance ratio, is to place wire coils in a pipe or duct. In this study, the heat and pressure drop characteristics of diamond, triangular, and circular cross-sectional wire coils (DWC, TWC, and CWC) in a square duct were investigated by using the FLUENT program. In addition to the cross-section examination, the thermo-hydraulic behavior of three different pitches (p = 54, 72, and 90 mm) for the specified geometries were also investigated. The Reynolds number was between 4387 and 18,415. The square duct was 1.25 m in length, and was 18 mm in diameter. The results showed that the Nusselt number of CWC, TWC, and DWC were higher than that of a smooth pipe within 38–88%, 37–93%, and 38–98% range, respectively. The friction of CWC, TWC, and DWC was observed to be higher than that of a plain tube within a range of 87–278%, 82–266%, and 107–366%, respectively. The TWC with 90 mm pitch showed the highest heat transfer performance evaluation criteria (PEC) with a performance coefficient of 1.3 at Reynolds number of 4504, whereas the DWC with 54 mm pitch was observed to show the lowest PEC. Thus, the as-obtained PEC, which is 30% higher than that of a plain tube, indicates the prominence and effectiveness of the numerical study in increasing the heat transfer.

Anahtar Kelimeler

Fluent, Thermo-hydraulic, Friction, PEC, Wire coil

Kaynakça

• The article references can be accessed from the .pdf file.